Heated Bidet

INSTALLATION INSTRUCTIONS - Brondell Bidets

General Installation Instructions for the Brondell Swash Bidets with Heated Toilet Seat

NOTE: Please read the instructions packaged with your Swash heated bidet before you begin the installation process. Ensure that the size and shape of the toilet is suitable for installing your new, heated toilet seat and bidet.

WARNING: Use the correct voltage according to the Specifications Table and connect to a grounded (3-prong outlet).

CAUTION: DO NOT CONNECT THE POWER UNTIL INSTALLATION IS COMPLETE. ONLY AUTHORIZED SERVICE PERSONNEL SHOULD GROUND THE CONNECTION.

NOTE: Do not disassemble or modify the Swash bidet. Only an authorized service representative should perform repairs.

Swash Bidet Parts and Configuration

Swash Heated Bidet with Heated Toilet Seat - Parts and Configuration

Tools needed to install the Swash bidet with heated toilet seat.

Universal Wrench (included)
Flat-head Screwdriver
Phillips Screwdriver
Measuring Tape

NOTE: The universal wrench included with the bidet will work for most applications. Depending on your toilet configuration, an adjustable wrench may also be needed.

The instructions provided on this web site are intended for general informational purposes only. Please refer to your Swash Bidet Owner's Manual for complete installation and operation instructions.

STEP 1: Remove Existing Toilet Seat 1a: Lift hinge covers and use a screwdriver to remove the mounting bolts. 1b: Remove the toilet seat. NOTE: Steps may vary by type of toilet seat.
STEP 2: Turn Water Off and Flush Toilet 2a: Turn water valve off completely. 2b: Flush the toilet to empty the tank. 2c: Disconnect the water supply line from the toilet tank. NOTE: Complete these steps before proceeding! Failure to do so could result in flooding, leaking, or damage to the Swash bidet.
STEP 3: Install Mounting Plate 3a: Place mounting plate over mounting holes, flat side down with curve towards the back of the toilet. 3b: Insert bolts through the mounting plate and hand-tighten the nuts. If mounting bolts are too long for the toilet, place bolts one at a time in a towel and break bolts at section without the threads. 3c: Adjust mounting plate so length (L) between the front of the toilet bowl and the back of the mounting plate is as follows: Round (S400-RW): L=18¼ (465 mm) Elongated (S400-EW): L=19½ (495 mm) 3d: Tighten mounting bolts with screwdriver until the mounting plate is securely fastened to the toilet.
STEP 4: Connect T-valve and Hoses 4a: Install the T-valve between the water supply line and the toilet tank. 4b: Place the Swash bidet on or beside the toilet and connect the bidet hose to the Swash bidet. NOTE: Use wrench to gently tighten all connections before continuing. Failure to do so could result in flooding, leaking, or damage to the Swash bidet.
STEP 5: Attach the Swash Heated Bidet Slide the bidet onto the mounting plate. (You will hear a "click", indicating that the seat has been properly attached.) To release the Swash bidet, push the button located on the right-hand corner of the seat and gently pull.
STEP 6: Turn on Water and Connect Power 6a: Turn the water valve back on slowly. Ensure that the connections are not leaking before continuing. 6b: Make sure your hands are dry. Insert the power plug into a grounded GFCI outlet. The blue power LED will illuminate.